Eliminating Faults - Festo VZWM Instrucciones De Utilizacion

VZWM
11

Eliminating faults

Fault
The VZWM
diaphragm
valve vibrates
or does not
switch switch
The VZWM
diaphragm
valve does not valve does not
switch
Loud switch
ing noises
Fig. 7
The diaphragm valve has been calibrated by the manufacturer by means of the
regulating screw
Festo personnel.
Avoid modifications to this setting.
S
If necessary, contact Festo AG & Co. KG.
S
Festo VZWM 0612NH English
Possible cause
Pressure difference
too low
Exhaust hole in the
output covered
Valve defective
Solenoid coil
defective
High pressure shock
2
(è Fig. 1). This setting should be undertaken only by qualified
Remedy
S Check the application parameters.
S Make sure that the diference in pressure
between the input (connection P) and the
output (connection A) exists permanently.
S Remove the sealing material in front of the
exhaust hole.
S Return the diaphragm valve to
Festo AG & Co. KG.
S Check that the solenoid coil is functioning
correctly and, if necessary, replace it.
S Select valves and tubng diameter not too
small.
S Insert a bypass for switching steps.
S Switch off the pump before interrupting the
flow.
S Insert a piston valve with closing time
regulaton.
25