Display And Operation; Standby Mode; Operation Mode - Ditel SYROS SY24 Manual De Instrucciones

4 Display and operation

SY24

Standby mode

To perform standby operation, set "STby" as ON in the 1st block parameter.
SV indication lamp flickers
Showing the
process
value (PV)
SV indication lamp is lit
Showing the
set value
(SV)

Operation mode

Showing
the
process
value (PV)
SV indication lamp is lit
Showing
the
set value
(SV)
The set value (SV)
Can be changed.
Parameters setting mode
Press the for 2 seconds
3 Shift to operation condition
Operation mode
Parameter setting procedure:
1 Select a parameter you want
to set by pressing the or
key
2-1 Press the key to display the
parameter set value.
2-2 Press the or key to
change the parameter set value.
2-3 After the parameter has been
changed, press the key for
registration.
3 To shift to Operation/Standby
press the key for 2 seconds
4 If unoperated state continues for
30 seconds, it returns to
Operation/Standby mode.
1
Change of set value (SV)
2
Shift to the 1st, 2nd and 3rd block parameter To shift to the other
blocks, press the
the block to shift.
1 Parameter selection
Parameter search
Press The Press The
parameters can be displayed according to the
parameter list shown in "5, Setting methods of .....
Aviso:
La visualización del SV no parpadea mientras
el 1er, 2º y 3er bloque de parámetros se están
visualizando.
key.
: Depending on the pressing time of
Pressing time
About 1 sec pressing
About 3 sec pressing
About 5 sec pressing
2 Parameter settings
Press
The key
once
Parameter set value change
Increases set value
Decreases set value
Registers parameter set value,
returning to the parameter shift mode
Press
The key
once
By repeating the same procedure, the
17
Switching by 1st
block STby settings
key, you can select
Shifting block
1st block
2nd block
3rd block
Switching by
the
When the set value is changed
the numeric value flickers.
1
If it is left in this state for 30 seconds,
the change becomes invalid, and it
returns to Operation/Standby mode.
After the parameter has
been changed, if unoperated
continues for 30 seconds
pressing the key, setting change
becomes invalid
key
state
without