Assembly - Astralpool Waterlift Manual De Instrucciones

12. Without changing the position of the drum and end of travel screw, remove the pulling cable set screw
in the transmission drum with the help of a number 6 Allen key.
CAUTION
When removing the pulling cable set screw, and in order not to change the calibration of the
moving step top and bottom positions avoid, in particular, any excessive movement of the drum
from its original position.
Fig. 33: Removal of the end of travel screw from the drum.
13. Replace the cable.

9.4.2 Assembly

To reassemble the unit:
Carry out the points explained in section 9.4.1 in reverse order. Bear in mind that instead of pulling
and using gloves, you will have to wind the pulling cable around the drum as can be seen in figure 34.
CAUTION
When the pulling cable is held with the set screw and in order not to change the calibration of
the moving step top and bottom positions avoid, in particular, any excessive movement of the
drum from its original position.
During the cable assembly process in the drum, keep a constant traction in the cable so that
it is in as similar a situation as possible to its operation position.
Take special care not to twist or bend the traction cable excessively during handling.
Instruction Manual Waterlift rev.0.7 -06/09
Maintenance
29/196