Publicidad
Idiomas disponibles
Idiomas disponibles
5
4
10
Cut-out areas
4
Rear view
- Slide the two insertion angles
tube.
NOTE: the cut-out areas on the insertion angles must face the center of
the vehicle.
-
Fasten the rear crossbar
two M8x16 flat head screws with hexagon socket
yet.
-
Fasten the top case supporting plate
screws with hexagon socket
-
Now you can align the top case supporting plate by tightening the four
flat head screws
. Afterwards, tighten all of the retaining screws that
2
are still loose.
-
Finally, fasten the lower rear with the previously loosened M6x10
screws (Fig. A); mount the two silencers, rear fender and seat.
Warning: Check all connections for a tight fit after driving 50 km.
The max. payload is limited to 12 kg.
Suitable top cases:
Top case 37, KTM no.: 60012027200
Top case 46, KTM no.: 60012027300
2
1
5
3
10
bk
in the left and right rear frame
9
to the two insertion angles
bl
using the four M8x20 flat head
1
2
and the four M8 nuts
bk
, using the
- do not tighten
3
.
4
9
3
11
6
8
7
Publicidad
