U.S.Robotics 8000a Guia De Instalacion página 9

4
To configure the Broadband Router for your specific ISP, launch a Web browser and type http://
192.168.123.254 to access the Configuration Utility. There is no default password for the Broadband
Router, so just click Login. Click Setup and follow the on-screen instructions. You will need any network
connection information you collected earlier.
Note: If you collected any network information earlier, you will need to enter this information into the
Setup WAN configurations screens.
5
After you have performed the configuration steps, the installation procedure is now complete. You
should now have secure and shared Internet access. To verify your connection, launch a Web browser
and go to www.usr.com. If the page loads, you are finished with the installation procedure. If the page
does not load, proceed to the Troubleshooting section of this Guide.
Note: It is recommended that you write down the settings for your Broadband Router for future
reference. You can view the settings in the Broadband Router Configuration Utility by logging in at http:/
/192.168.123.254.
The following graphic is a representation of your system topology after the installation of the Broadband
Router.
Connecting a Cable or DSL modem to the Broadband Router
5