Ikegami IPD-Q01 Manual De Instrucciones página 7

Lens mount (CS)
①
Used to mount the lens. Various types of CS mount lenses can be applied.
Auto iris connector
②
Used to connect an auto iris lens.
Lens selector switch
③
Used to select between VIDEO iris and DC iris according to the type of an auto iris lens.
Iris level adjusting knob
④
Used to adjust the iris level with a DC lens in use.
⑤ Camera mounting screw hole
Used to fix the camera to the camera holder. The camera can also be set up on an ordinary
tripod.
Note: To secure the camera on a tripod or the camera holder, be sure to use a mounting
screw (1/4"-20UNC) shorter than 5.5 mm.
⑥ Vent
Used to vent hot air through the cooling fan.
⑦ Flange focus adjuster
There might be a need to adjust the flange focus depending on a lens used. Use this control
if the focus ring on the lens fails to get the image in focus.
⑧ Flange focus lock screw
Used to mechanically lock the camera's flange focus adjuster after fine adjustment.
⑨ ETHERNET
Used to connect the LAN cable (Category 5 or higher). PoE-compatible.
⑩ LED indicators
POWER (green)
STATUS (orange) : Normally flashing
⑪ Power input terminals
The terminals are commonly used for DC12V and AC24V power. These terminals have prior-
ity over the PoE power system, if the power is supplied at once from both systems.
* This installation should be made by a qualified service person and should conform to all
local codes.
INIT switch
⑫
* Get the system started and hold down this switch, and the IP address and other data are
introduced via the video output terminal (monitor)
onscreen pages change. Hold down the switch again, and the data disappears.
* Hold down the switch, turn on the power and keep it down for more 10 seconds. This will
return the product's settings to its factory ones. It is helpful if the firmware fails to be up-
loaded, for example. In such case, the IP address and the firmware itself resume their
factory settings. The IP address and other settings must be made again.
⑬ Video output terminal
Used to send out video signals. The cable from this terminal is connected to the video input
terminal of a monitor or a switcher.
⑭ Alarm terminals
IN : Normally open no-voltage contact alarm input. External sensor or the like connected
here.
OUT : Open-collector output. Alarm output given if the motion detector gets activated or if
the IN terminal gets short-circuited.
Mic input terminal
⑮
Used to connect a microphone. Hook up a microphone as required.
⑯ Audio output terminal
Used to send out audio signals. Connect an external audio output device (LINE terminal) to
this terminal.
: Normally flashing
⑬ . Then just press the switch, and the
E-3