General Precautions; Electrical Connection; Accessories And Spare Parts - Facom 777A.230F Guía De Instrucciones

GENERAL PRECAUTIONS

The selection and use of components have been carried out taking into account the operating conditions and life span of the machine. Install
the machine in such a way as to avoid any danger to exposed personnel provided that it is properly used. No protection or warning will be ever
sufficient if the operator fails to take certain precautions, if the machine is not maintained in the best operating conditions and if the following
recommendations are not complied with. Before starting work, learn how to use and adjust the machine correctly. Check that the operator works
safely and thoroughly knows the operation of the machine. Avoid exposing yourselves and anybody else to unnecessary risks. Insist on having
personal protection systems used wherever prescribed. Do no remove, modify or inhibit any SAFETY DEVICE installed by the manufacturer, and
check that they are not removed or rendered less effective. Constantly check that the equipment is perfectly efficient without any anomaly which
might damage persons or things. Work in tidy, risk-free premises with adequate lighting and room. Keep any unnecessary tools or other objects
away from the working area.
INSTALLATION
- NOTE: before using the lamp carefully read the following instructions.
- Ensure that the lamp can be disconnected from the electrical supply in case of emergency.

ELECTRICAL CONNECTION

- Make sure that the portable lamp power supply matches the system power supply.
- Use the lamp in places prescribed and designated by current regulations regarding the workplace and electrical systems.
- Check that the plug on the cable is appropriate to the particular workplace; replace if necessary.
- The wiring should be carried out by qualified personnel, according to the following instructions.
OPERATING INSTRUCTIONS
- Insert the plug in an appropriate socket.
- Use the switch to switch on and off.
- Always check that the device is in full working order and shows no safety risks.
- Do not remove the protection guards.
- Do not open the device: maintenance should be carried out by qualified personnel.
- Before replacing the bulb disconnect the lamp from the electrical supply.
- If the feeder cable is damaged it should be replaced immediately with another of the same type at an authorised after-sales centre or by a
qualified electrician.
The lamp features two hanging hooks and two magnets on the rear that help to facilitate hands-free working.
IF THE DEVICE DOES NOT WORK
- Check that the voltage of the portable lamp is working efficiently and matches the system voltage.
- Check that there is power at the socket.
- Check the operation of the switch: that is, that it depresses and engages then disengages fully.
- If the device continues not to work contact a specialised repair centre.

ACCESSORIES AND SPARE PARTS

Use only accessories and spare parts approved by the manufacturer.
Additional Instructions – 777A.230F and 777A.24F
CAUTION
DO NOT USE IF Damaged. Always thoroughly inspect the reel and lamp before each use.
Ensure the product is connected to a power source with the correct voltage rating.
ALWAYS CHECK that the plug connecter is fully inserted into the outlet socket. Do not remove, bend or modify any metal prongs or pins of the
plug connector.
DO NOT USE WHEN WET. Keep away from water and do not expose to rain or moisture.
AVOID OVERHEATING. Do not expose to extreme heat or flame. Uncoil the cable and do not cover with any material.
Power cable should not run through door ways, holes in the ceilings, walls or floors and ensure the working are is kept clean.
DO NOT drive, drag or place objects over the cable, keep children and pets away from the cable.
DO NOT disconnect the power source by pulling on the cable or use excessive force on the cable assembly.
DO NOT disassemble any parts for any reason, if the device does not work correctly contact a specialised repair centre.
Never remove or tamper with the safety devices fitted to the reel.
NU-777F_1015 ok.indd 6 10/19/2015 8:48:14 AM