Common Errors - Avery Dennison Monarch 9906 Referencia Rápida

Common Errors

Error Description/Action
002 Name must be 1 to 8 characters inside quotes.
005 Invalid supply width.
018 Invalid code page selection.
025 Data length is too long.
101 Format referenced by batch not in memory.
400 Invalid character following {.
403 Field separator was not found.
409 Printer memory is full. Delete unused items.
410 Parity mismatch.
411 Framing error (baud rate mismatch).
412 Flow control mismatch.
413 Online receive buffer is full. Check flow control.
611 Font, bar code, or density in the batch does not fit the format.
612 Data in this line of the batch is missing or doesn't match format.
613 Reference point off supply.
614 Portion of field off supply or invalid character in the packet.
703 Printer sensed a calibration of different-sized black marks.
Make sure the correct supply type is loaded.
Printer has not sensed a supply mark when expected or is out
704
of supplies. Make sure your printer is set to the appropriate
supply type. Reload supply. Clean the sensor.
751 Printer did not sense a black mark when expected. Press
ESCAPE to continue printing. Change supply.
752 Printer sensed a mark in the wrong place.
753 Printer sensed a mark that is too long.
Check for a ribbon jam or remove any slack in the ribbon. Load
754
a new ribbon.
755 Printhead is open. Close the printhead.
756 Load supply and/or clean the sensor.
757 Load supply (supply length mismatch). Press FEED.
758 Supply is not seen, on-demand sensor is broken, or a label was
removed too quickly. Check for a label jam or reload supplies.
Waiting to dispense label. Press FEED.
763
Printhead has less than 8 bad dots and can shift bar code fields
765
to avoid bad dots. Press ESCAPE to continue printing.
768 Printhead has more than 8 bad dots or is not connected.
Connect or replace the printhead.
EN-11