Audio Setup Page; Video Setup Page - Soundstream H-200MDi Manual De Instrucciones

4:3 PANSCAN
This mode is used with 4:3 televisions. 4:3 images are
displayed normally. When showing 16:9 programmes,
the full height of the screen is displayed, and the left
and right part of the image are cut off.
4:3 LETTERBOX
This mode is used with 4:3 televisions. 4:3 images
are displayed normally. 16:9 images are visible at
their full width, but there are blank area at the top and
bottom of the screen.
16:9
Use with a 16:9 wide television.
Some wide-screen discs that do not permit the

Pan Scan mode playback are automatically played
in Letter Box mode.
Depending on the DVD, 4:3 Letter Box may be

selected automatically instead of 4:3 Pan Scan
and vice versa.
If 16:9 (Wide) is selected and a normal TV is

connected, 16:9 content will appear distorted
during playback (objects look thin).
OSD (On Screen Display) Language
Select the desired language for on screen menus of
the unit.
Closed Captions
On
Show the captions.
Off
Close the captions.
Screen Saver
On
The screen saver starts up if nothing is played back
and no operations are performed for 4 minutes.
Off
The screen saver does not start up.
Last Memory
On
Select this to make last memory function available.
Off
Select this to make last memory function invalid.

Audio Setup Page

Downmix (Analog Audio)
LT/RT
5.1 channel audio is mixed into left channel and
right channel and is output via FL and FR speakers
respectively.
Stereo
5.1 channel audio is mixed into stereo signal and is
output via the FL and FR speakers.
Off
Select this to make this function invalid.
Note:
Only for Dolby AC-3 encoded 5.1- channel discs.
Reverb Mode (3D Processing)
This setting provides following sound effects:
Off, Concert, Living Room, Hall, Bathroom, Cave,
Arena, Church

Video Setup Page

Notes:
Component setup and quality setup is invalid until
HDMI is setted to off.
CVBS
If the component connection is used, select this option.
YUV
S e t t h e v i d e o o u t p u t a c c o r d i n g t o t h e v i d e o
connection.
Color Setting
You can adjust some parameters of video picture.
1 Highlight "Color Setting" and press the
2 Use the / buttons to select the parameter.
 
Sharpness
This adjusts the sharpness of the picture shown on
the monitor.
Select High, Medium or Low using the Cursor buttons,
and press the ENTER button.
Brightness
This adjusts the brightness of the picture.
Use the left and right buttons to change the value,
and press the ENTER button.
Contrast
This adjusts the picture contrast.
Use the left and right buttons to change the value,
and press the ENTER button.
Gamma
This adjusts the gamma value of the picture.
Select High, Medium, Low or None using the Cursor
buttons, and press the ENTER button.
Hue
This adjusts the green/red balance of the picture (only
for progressive-scan and S-Video output).
Use the left and right buttons to change the value,
and press the ENTER button.
Saturation
This adjusts the saturation level.
Use the left and right buttons to change the value,
and press the ENTER button.
12
button.
