Listening To The Fm Radio; Tuning In A Station; Presetting Stations; Tune To A Preset Radio Station - Soundstream H-200MDi Manual De Instrucciones

1 Select the desired parental control level from the
menu, then press ENTER button.
2 You will be prompted to enter your password.
Use the 0-9 buttons to enter 000000 (or your
privacy password if already established).
No need to enter a password if "Password Mode"

is set to OFF.
Password
Password Mode
You can temporarily unlock discs for playback
according to the level.
To change this setting, select On or Off, enter your
password, and press the ENTER button.
On
You need a password to change the level of
parental control.
Off
You can change the level of parental control
without a password. You cannot temporarily
unlock discs for playback.
You can set a new password for parental control.
The default password is 000000.
1 Select "Change" and press the ENTER button.
2 Enter 000000 (or your privacy password) using
the 0-9 buttons.
3 Enter a new password.
4 Enter the same password again to confirm.
5 Press ENTER button.
Note:
you will need your password to change the level of
control in the future as well as to temporarily unlock
discs for playback.
If you forget your password, use 000000.
Default
All the items in the Setup menu (except for the
password and parental control) will be reset to the
default settings.

Listening to the FM Radio

T uning in a Station
1 Ensure that you have connected and fully extended
the FM antenna.
2 Press the TUNER button to select the TUNER source.
3 Press the
D/C
down or up automatically until a station is found.
Or press / buttons repeatedly until you find the
 
station you want.
Note:
- You can press
BF
to search stations or press and hold
buttons, the frequency changes
PLAY button on front panel
BF
on the remote control to change grid.
- The unit will automatically switch the Stereo or
MONO channel to receive the FM radio mode, it
can get the best effect.

Presetting Stations

You can preset up to 20 FM stations.
Program radio stations automatically

Press and hold the PROG button for 2 seconds to
activate automatic programming. All available stations
are programmed in the order of waveband reception
strength.
- The first programed radio station is played
automatically.
Program radio stations manually

1 Tune in the desired station, then press the PROG
button.
2 Press the 0~9,
preset number.
- 0~9 Select the preset number directly
-
H
-
G
3 Press the PROG button to store the station.
4 Repeat above steps 1 to 3 for each station you
want to store in memory with a preset number.
5 Press and hold the
radio stations.
Note:
If the system is unplugged or if a power failure occurs,
the preset stations will not be erased.
T une to a preset radio station
Press the
that you want.
Note:
You can also use the numerical keypad to select a
preset station directly.

RDS Timer Sync

When a RDS station is found, time of the unit will get
out of sync with the RDS time.

Show RDS information

RDS (Radio Data System) is a service that allows
FM stations to show additional information. If you
tune to a RDS station, RDS and the station name are
displayed.
1 Tune to a RDS station.
2 Press the MENU button repeatedly to scroll through
the following information (if available):
- Station name .
- Program type such as [NEWS] (news),
[SPORT] (sport), [POP M] (pop music)...
- Frequency
button
- RDS Clock
14
or buttons to select the
H G
Decreases the preset number by 1
Increases the preset number by 1
button to erase the memory
L
or buttons to select a preset number
H G