Temperature Control; Releasing A Column - Necta Zeta CB Serie Instalación, Uso, Mantenimiento

If a single column, a plastic diaphragm, hooked to the
upper side of the column.
In order to correctly load the column, do as follows:
- release the diaphragm by lifting it by its grip;
- load some bottles in the back row (to half height) and
position the diaphragm against it;
- load the bottles in the front row;
- complete loading of the back row and re-hook the
diaphragm .
Fig. 13
1 - Diaphragm
2 - Diaphragm grip
3 - Diaphragm hook
- complete loading of the column.
After completely loading the machine:
- close the retaining gate:
- after all loading operations make a test selection for
each product.
All loading operations must be carried out as quickly as
possible, to limit as much as possible the increase of
temperature inside the refrigerated box and therefore
power consumption.
© by NECTA VENDING SOLUTIONS SpA

TEMPERATURE CONTROL

The thermostat is initially adjusted so that a temperature of
+1.5°C is maintained in the lower portion of the refrigerated
box (containing bottles and cans which will be sold first).
The thermostat is located next to the refrigerating unit (see
Fig. 5).
To change temperature, turn the thermostat knob keeping
in mind that the temperature is approximately:
position "7"
position "1"
position "OFF"

RELEASING A COLUMN

It may occur that, for any reason, the products are jammed
in the dispensing area.
In this case, to restore the full functionality of the jammed
column, do as follows:
- manually empty the concerned column, being sure that
the rotor area is clear;
- move minidip 6 on the control card (see Fig. 14) to
position ON.
- close the door and wait a few seconds to allow the
motor to reach the correct position;
- open the door and move minidip 6 back to position OFF
- reload the column and close the machine, then check
that the corresponding selection is working correctly.
48
= + 1,5°C
= + 5°C
= Switched off
Fig. 14
1 - Control board
2 - Minidip
01 10 126-03