Programming; Control Board Functions And Indicator Lights - Necta Zeta CB Serie Instalación, Uso, Mantenimiento

PROGRAMMING

The integrity of the vending machine and its conformity
with the rules and regulations in force for its relevant
systems must be checked by qualified personnel at least
once a year.
Maintenance operations should be carried out with the
machine energised and therefore exclusively by qualified
personnel, who are trained in the correct use of the machine
and aware of the specific risks of such condition.
To energise the electrical system of the machine with the door
open, simply insert the special key into the door switch.
The dispensing motors remain disconnected, thanks
to the special switch (see Fig. 5), even with the key
inserted.
This is to avoid the risk of accidental injury.
The rotors must be electrically operated with the door
closed.
Energised parts cannot be accessed with the door
open. Only those parts inside the machine with protec-
tive covers, and carrying the message "disconnect
electricity before removing the protective cover", re-
main energised.
Before removing such protective covers, the external
switch must be disconnected.
The door can be closed only after removing the key from the
door switch.
CONTROL BOARD FUNCTIONS
AND INDICATOR LIGHTS
The control board controls all of the apparatus functions,
and more precisely:
- Serial interface for 24 V ac Executive electronic coin
mechanism.
- Parallel interface for 24 V dc coin validator
- Serial interface for MDB coin mechanism.
- Programming of the number of selections: 1 to 10.
- Programming of the vending price for each single
selection.
- Time-out function for the vending motors, adjustable
from 0 to 30 seconds.
- Programming of the coin values for use with 24 V
validator.
- Storing of the total sales for each selection.
- Storing of the total amount of all sales.
- Storing of the total coin value cashed.
- Storing of the motor locks following a time-out condi-
tion.
- Storing of the total motor resets.
- Storing of the number of serial transmission failures
occurred.
© by NECTA VENDING SOLUTIONS SpA
Fig. 27
CN1 Executive serial interface
CN2 MDB serial interface
CN3 RS232 expansion
CN4 Not used
CN5 24 V validator interface
CN6 Not used
CN7 LED segment display
CN8 Provision for LCD
CN9 Input/output keypad 1 to 6
CN10 Input/output keypad 7 to 8
CN11 Input/output keypad 9 to 10
CN12 Empty state micro-switch, motor cam 1 to 7
CN13 Empty state micro-switch, motor cam 8
CN14 Empty state micro-switch, motor cam 9 to 10
CN15 Motor output 1 to 8
CN16 Motor output 9 to 10
CN17 Board power supply
CN18 Not used
CN19 MDB power supply
CN20 Not used
CN21 Not used
F1 Motor fuses
F2 24 Vac board power supply fuse
RL1 - 10 Motor relays
J9 Reset contacts
LED L1 is normally switched off; it blinks when no commu-
nication takes place with the coin mechanism.
LED L2 is switched on when 24 V dc voltage is detected.
LED L3 is switched on when 5 V dc voltage is detected.
Trimmer TR1 controls the contrast of the liquid crystal
display (available as optional).
Push-button P1 resets the control board.
5 5
01 10 126-03