Greasing The Gas Tap; Replacing Parts - Angelo Po 1G0TP0 Manual De Uso E Instalación

GREASING THE GAS TAP

To carry out this operation, proceed as follows.
1 - Turn off the gas supply tap.
2 - Pull off the knob (A).
3 - Undo the scr ews (B) and remo ve the control
panel (C).
4 - Undo the screws (D) and extract the cap (E).
5 - Pull off the cone (F).
6 - Clean the cone (F) and its seat.
IT
GB
RECOMMENDATIONS FOR REPLACING PARTS
Before carrying out any replacement procedure, ac-
DE
tivate all the safety devices p rovided and decide
whether staff at work and those in the
FR
should be informed. In particular, turn off the gas
supply tap and prevent access to all devices which
might cause unexpected health and safety hazards
ES
if turned on. If work parts have to be replaced, use
original spare parts only. T he manufacturer de-
English
B
A

REPLACING PARTS

vicinity
7 - Coat the con e with grease (F), fit it in its seat
and turn it a few times.
8 - Pull off the cone
grease.
9 - Replace the cone (F) and the cap (E).
10 - Replace the control panel (C) and the knobs (A)
on completion of the operation.
E
C
D
clines all responsibly for injury or d amage to com-
ponents due to the use of non or
extraordinary work on the appliance wh ich may
modify the safety requ irements without the manu-
facturer's authorisation. When or dering compo-
nents, follow the instructions provided in the parts
catalogue.
- 26 -
(F) to r emove the excess
F
IDM-39618301500.tif
iginal parts, or
9