Angelo Po 1G0TP0 Manual De Uso E Instalación página 62

REPLACING PLATE BURNER AIR BUSHING
To carry out this operation, proceed as follows.
1 - Turn off the gas supply tap.
2 - Pull off the knob (A).
3 - Undo the scr ews (B) and remo ve the control
panel (C).
4 - Undo the screw (D).
DECOMMISSIONING AND SCRAPPING THE APPLIANCE
When decommissioning the applia nce, a series of
procedures must be carried out to ensure that the
IT
appliance and its components ar e not a hindr ance
and are not easily accessible.
GB
To ensure that the appliance cannot constitute haz-
ards for people or the environment, all ener gy
sources (electricity, etc.) must be disconnected and
DE
rendered unusable, and any liquids present must
be drained (lubricants, fluids, etc.).
FR
Place the appliance in a suitable area which is not
easily accessible, with barr iers to prevent anyone
ES
English
B
C
A
- 30 -
5 - Extract the bushing (E) and replace it with the
one suitable for the type of gas in use (see table
at back of manual).
6 - Tighten the screw (D).
7 - Replace the control panel (C) and the knobs (A)
on completion of the operation.
E
from accessing it.
When scrapping, sort all components by chemical
characteristics and dispos e of them separately in
accordance with the relevant legal requirements.
Important
Do not dump non-biodegradable products,
lubricating oils, and non-metallic compo-
nents (rubber, PVC, resins, etc.) in the envi-
ronment. Dispose of them in compliance
with the relevant laws.
D
IDM-39618702000.tif