7.5. Adding/deleting RTS sensors
Find an RTS transmitter programmed in the motor.
Press and hold the programmed RTS transmitter (A)
PROG button until the shade jogs: the motor is in
programming mode.
Press briefly the RTS sensor (C) PROG button to add
or delete this sensor: the shade jogs and the RTS
sensor is programmed or deleted from the motor.
7.6. Erase the memory of the motor
This reset deletes all RTS transmitters,RTS sensors,
end-limits and intermediate position programmed.
Only switch off the current for the motor to be reset!
Before cutting the power, move the shade to the
middle position.
1) Cut the power supply for 2 seconds.
2) Switch the power supply back on for 10 to 15
seconds.
3) Cut the power supply for 2 seconds.
4) Switch the power supply back on: the shade
moves during 5 seconds (If the shade position
is an end limit, the behavior of the shade will be a jog).
5) Press the RTS transmitter (A) PROG button
until the shade jogs twice: all the RTS transmitters,
RTS sensors, end-limits and intermediate position are
cleared.
© 2013 Somfy SAS. All rights reserved. 12/2013
A
+
PROG.
A
C
-
PROG.
A
1
2
2 sec
3
4
2 sec
5
PROG.
A
X 2
B
C
PROG.
C
C
PROG.
C
10 to 15
sec
A
B
C
MY
11