Dust Collection - Amano American Sanders OBS-18 Manual Del Operador

Section - A
WARNING:
Do not cut, remove or break the ground pin. If the outlet does not fit the plug, consult your electrical contractor.
WARNING: Have worn, cut or damaged cords replaced by an authorized service person.
Grounded
Outlet
Grounding
Pin
(United States, Mexico and Canada)
Figure 12
CAUTION:
This machine will operate only on the AC frequency and electrical voltage shown on the nameplate. Make sure you have the
correct frequency and voltage before connecting the power cord to an outlet.
This machine must be connected to the electrical ground to protect the operator from electric shock. The machine has a power cord with two
main conductors and one earthing conductor. Connect the plug to the type of receptacle shown in figure 5. The green and yellow conductor
cord is the ground wire. Never connect this wire to any terminal other than the ground terminal.
Figure 5
This sanding machine is designed to be operated with a remote vacuum dust collection system or with the included dust bag.
Preparing Remote Vacuum Dust Collection Systems
To prepare the machine for remote vacuum dust
collection systems that have a 2" hose end, follow this
procedure:
1. Install 2" hose end (Figure 4 - A) directly into the
exhaust tube (Figure 4 - B).
2. The exhaust tube can be rotated for optimum
convenience.
To prepare the machine for remote vacuum dust
collection systems that have a 1-1/2" hose end, follow this
procedure:
1. Install 2" Tube x 1-1/2" Hose Adapter onto the end
of the 2" hose. (Figure 4-C)
2. Install Hose Adapter directly onto the exhaust tube.
3. The exhaust tube can be rotated for optimum
convenience.
NOTE: Start the remote vacuum collection system
before operation.
Grounded
Outlet
Box
Electrical Connection Instructions (230V)

Dust Collection

WARNING:
Always use this machine with an AC three-
conductor electrical system connected to the
electrical ground. Replace any worn, cut, or
damaged cords. Replace any damaged plugs,
receptacles, or connector bodies. Do not move
the machine over an electrical cord. Always lift
the cord over the machine.
2" Hose from
Vacuum System
(Not included)
Figure 4
B
Exhaust
Tube
8
English - EN
1-1/2" Hose from
D
A
Vacuum System
(Not included)
(30563A)
C
2" Tube X 1-1/2"
Hose Adapter