Promax PROLITE-67 Manual De Instrucciones página 110

B.- Measuring Attenuation Test.
1.- Connect the PROLITE-105 in a source node of the transmitting optical
network, such in a free strip of the general telecommunication cabinet at the
building.
2.- Keep the PROLITE-105 in SIMULTANEOUS mode. The source generates
simultaneously the same wavelength (1310 nm, 1490 nm and 1550 nm).
3.- Connect the PROLITE-67 in a receiving node of the optical network that you
want to measure, such as a UAP (User Access Point).
4.- Activate the ATTENUATION TEST function on the PROLITE-67.
5.- Check the measurement and store it on the memory of the device by pressing
the key
6.- Repeat the previous step for each one of the access points (see Figure B).
C.– Printing the Certification Report.
1.- Connect the PROLITE-67 to the PC where you have installed the control
software.
2.- Run the control software.
3.- Click on the ICT Test tab.
4.- Click on the Receive loggers from the equipment button.
5.- The lower right window shows the loggers stored on the instrument.
6.- Select some records for making a report.
7.- Click on the CERT icon that is on the right of the data record.
8.- Fill in the information and click on Generate Certificate.
9.- It generates a ICT certification report in PDF format that is saved by default in
the Certificates folder or in a folder selected by the user (see Figure C).
Page 48
.
USER'S MANUAL. PROLITE-67
07-2012