Publicidad
Idiomas disponibles
Idiomas disponibles
AVAILABLE
ACCESSORIES
Visit your Sears Hardware Department or see the Sears
Power and Hand Tool Catalog for the following acces-
sories.
ITEM
STOCK NUMBER
* Auxiliary Fence, Rip Fence
29878
* Miter Gauge Extension & Stop
29879
* Stock Clamp, Miter Gauge
29880
* Dust Chute with Dust Port
22102
* Micro-Adjustment
Assembly
29881
* Table Insert - Standard
29882
* Table Insert - Dado
29885
* Table Insert - Molding Cutterhead
29887
* Saw Blade - Leitz, 10-in. x 40 tooth
29888
variable pitch blade
* Fence Guide System
32371
Sears may recommend other accessories not listed in
this manual.
See your nearest Sears Hardware Department or Sears
Power and Hand Tool Catalog for other accessories.
Do not use any accessory unless you have completely
read the Owner's Manual for that accessory.
Use only accessories recommended
for this table saw.
Using other accessories may cause serious injury and
cause damage to the table saw.
Fig. 2A
CONSTRUCTING
A FEATHERBOARD
24"
5"
Figure 2A illustrates dimensions for making a typical
featherboard.
The material, which the featherboard is
constructed of, should be straight piece of wood that is
free of knots and cracks.
Featherboards are used to
keep the work in contact with the fence and table and
help prevent kickbacks.
Clamp the featherboard to the
fence and table so that the leading edge of the feather-
board will support the workpiece until the cut is com-
pleted.
Fig. 2B
Use featherboards
for all non-through cutting opera-
tions where the guard and splitter assembly must be
removed.
Always replace the guard and splitter
assembly when the non-through cutting operations
are finished.
See figure 2B.
Publicidad
