Craftsman 152.221140 Manual Del Proprietário página 22

ON/OFF SWITCH AND
END CAP ASSEMBLY
MAKE CERTAIN the table saw is disconnected from
the power source.
Figure 14=1
5. Place the left front rail end cap (A) into the end of
the front rail (B). Attach end cap to rail with two
M4 x 16mm pan head self-tapping screws (C).
See figure 14-2.
6. Repeat step above to attach right side front rail
end cap.
CONNECTING SWITCH CORD
TO MOTOR CORD
J
J
1. Place two M6 x 12mm hex head screws (A) up
through the two holes (B) in the switch support (C).
See figure 14-1.
2. Thread two M6 square nuts (D) onto M6 x 12mm hex
head screws about three turns. See figure 14-1.
3. Slide the M6 square nuts and switch assembly (E)
into the left end of the front rail (F). See figure 14-1.
4. Position the switch assembly to desired location
and tighten hardware. CAUTION: Keep switch out
of saw blade path. Most common switch location is
to the left side of the saw blade.
Figure 14=2
MAKE CERTAIN the table saw is disconnected from
the power source.
Figure 15-1
B
A
1. Place the switch cord (A) through hole (B) in front
of cabinet. See figure 15-1.
2. Open motor cover, plug switch cord (C) into motor
cord (D). See figure 15-2.
3 Pull slack in switch cord into the cabinet.
Figure 15=2
C
3,
4.
22
D
Pull slack in switch cord into the cabinet.
Make a loop (E) from the slack of the switch cord
and place it behind cord retaining bar (F). See
figure 15-2.