Publicidad
Idiomas disponibles
Idiomas disponibles
RiP FENCE ASSEMBLY
MAKE CERTAIN the table saw is disconnected from
the power source.
Figure
11-1
C
C
A
"D
E
A
B
1.
Alignment bars (B) have set screws (A) already
installed. Make sure set screws are flush with face
of alignment bar. See figure 11-1.
2.
Place both fence front rails (C) on the saw table
upside down.
Make certain that the right fence rail
is on the right-hand side and the left front rail is on
the left-hand side. Check that both scales on the
front rails have the 1-inch marking close to each
other. See figure 11-1.
3.
Insert both alignment bars halfway into the back (D)
and bottom (E) square nut grooves in the right front
rail and slightly snug set screws to hold alignment
bar into the front rail. See figure 11-1.
4.
Slide the left front rail onto alignment bars and
against other half of front rail. Make sure both
sections of the front rails are flat and straight to
each other. Slightly snug set screws in both align-
ment bars. Recheck that the front rail is flat and
straight, then securely tighten all set screws.
Figure
11=2
F
O
G
G
19
5.
Slide the heads of four M8 x 35mm square head
screws (F), two from each end of the front rail into
the front rail. Note: The front rail is still positioned
upside down on the saw table. Position the screws
so that they will align with the two holes in the front
of the saw table and one hole in each extension
wing (G). See figure 11-2.
6.
Place front rail against front of saw table with the
four screws going through the four holes in the saw
table and extension wings.
Place an one M8 flat
washer, M8 lock washer and M8 hex nut onto each
of the four screws on the back side of the saw table
and extension wings.
Do not completely tighten the
four hex nuts at this point.
Figure
11=3
H
7,
Raise saw blade (H) and place a straight edge (I)
against right side of saw blade extending out over
front of saw table. Align the edge of the right front
rail (J) with right side of saw blade using the
straight edge. See figure 11-3.
Publicidad
