Publicidad
Idiomas disponibles
Idiomas disponibles
TABLE
iNSERT ADJUSTMENT
Figure
25=1
MAKE CERTAIN the table saw is disconnected from
the power source when making adjustments.
Figure
24=1
B
C
"A
C
A
/
1.
The table insert (A) must always be level with the
saw table (B). To adjust the table insert, loosen
and remove table insert retaining bolt (C). See
figure 24-1.
2.
Place a straight edge across the front and rear of
the table insert. Check that the insert is perfectly
level with the saw table.
3.
To level the table insert, turn the one or more
adjusting set screws (D) as needed and recheck.
See figure 24-1.
4.
Once the insert is level, secure the insert with the
retaining bolt removed in step 1.
5.
The table insert is equipped with a finger hole (E)
for easy removal. See figure 24-1.
CHANGING
MOTOR
VOLTAGE
1.
Make sure switch is "OFF" and disconnect power
cord from power source.
2.
Open motor cover and verify on the motor tag (A)
that motor is dual voltage.
See figure 25-1.
3.
If motor tag states that it is dual voltage remove junc-
tion box cover (B) on motor (C). See figure 25-1.
4.
Using wiring diagram on inside of junction box
cover, reconnect motor leads for 240-volt operation.
5.
Replace junction box cover and close motor cover.
6.
Replace 120 volt plug with a UL/CSA Listed 240
volt plug rated for current of the motor.
7.
The ON/OFF switch is 4-pole and does not need
modified.
• MAKE CERTAIN the table saw is disconnected from
the power source before working on motor.
• Have a certified electrician make all electrical connec-
tions. All local and state codes must be maintained.
The motor supplied with the table saw is a dual voltage
120/240-volt, single phase motor. The motor is wired
from the factory for 120-volt operation.
To change to
240-volt operation for your table saw, proceed with the
following instructions.
It is also necessary to replace
the 120 volt plug, supplied with the table saw, with a
UL/CSA Listed plug (not included) suitable for 240 volts
and the rated current of the motor. The table saw with a
240 volt plug should only be connected to an outlet
having the same configuration as the plug. No adapter
is available or should be used with the 240 volt plug.
32
Publicidad
