Safety Messages To Installers - Federal Signal Commander 371-120 Manual De Instalación Y Mantenimiento

Safety Messages to Installers

It is important to follow all instructions shipped with this product.
This device is to be installed by a trained electrician who is
thoroughly familiar with the National Electrical Code and/
or Canadian Electrical Code and will follow the NEC and/or
CEC Guidelines as well as all local codes. This light should be
considered a part of the warning system and not the entire warning
system.
The selection of the mounting location for the light, its controls
and the routing of the wiring are to be accomplished under the
direction of the facilities engineer and the safety engineer. In
addition, listed below are some other important safety instructions
and precautions you should follow:
• Read and understand all instructions before installing or
operating this light.
• Do not connect this light to the system when power is on.
• After installation, make sure that all set screws and threaded
joints are properly tightened.
• After installation, test the light to make sure that it is operating
properly.
• After testing is complete; provide a copy of this instruction
booklet to all personnel.
• Establish a procedure to routinely check the light for proper
activation and operation.
Failure to follow all safety precautions and instructions may result
in property damage, serious injury, or death.
Installation and Maintenance Instructions
Models 371-120 and 371L-120
5