Publicidad
Idiomas disponibles
Idiomas disponibles
CAUTION
l
Dispose of the contents of the dust
collection bag in an environmentally
responsible way. It may be neccesary to
wear a dust mask when emptying the dust
collection bag.
INSTALLING THE HOLD DOWN CLAMP
(Fig. C)
Two sockets (one on either side) are
incorporated into the rear of the machine
fence.
1. Fit the clamp into the retaining socket that
best suits the cutting application, ensuring
that it is fully pushed down.
2. Tighten the fence thumbscrew to lock the
pillar of the Hold Down Clamp into the fence
socket.
3. Put the workpiece to be cut onto the saw
bed.
4. Adjust the clamp using the thumbscrew
and hand-wheel so that it securely holds the
workpiece to the saw bed. Ensure that the
clamp does not interfere with the blade path.
(Fig. C)
INSTALLING OR REMOVING A BLADE
I A, WARNING
I
Only use blades which are designed for
this machine.
Ensure that the maximum speed of the blade
is compatible with the machine.
Only carry out this procedure with the
machine disconnected
from the power
source.
NOTE: Wear protective gloves when
handling the blade during installation and
removal.
1. Ensure the cutting head is up.
2. Remove the slotted head retaining screw
from the rear of the auxiliary blade guard.
(see page 14)
3. Remove the lower guard operating arm
pivot screw by inserting a Phillips Head
Screwdriver through the latching pin socket.
(Fig. D)
(Fig. D)
19
Publicidad
