Craftsman 126.32564 Manual Del Operador página 22

0°Bevel S top
Adjustment
1. Ensure that the Cutting Head is upright
against its stop and the Bevel Pointer is
indicating '0 °' on the scale. (Fig. J)
(Fig. J)
(Fig. L)
2. Place a combination square on the miter
table with the rule against the table and the
heel of the square against the blade. (Fig. K)
6. Use an Allen Key to turn the screw in or
out to adjust the blade angle.
7. Return the Cutting Head to its upright
position and recheck angular alignment
against the combination square.
8. Repeat steps 1 to 7 until correct angular
alignment is achieved.
9. Tighten the Bevel Angle Adjustment Screw
Iocknut securely.
0° Bevel Pointer Adjustment
NOTE: The operator must be satisfied that the
blade is set at exactly perpendicutat to the table
when inthe upright position and against its stop.
(Fig. K)
3. If the blade is not 900 square with the miter
table, adjustment is required.
4. Loosen the Bevel Lock Handle and tilt the
Cutting Head to the left.
5. Loosen the tocknut on the Bevel Angle
Adjustment Screw. (Fig. L)
1. If the pointer is not in exact alignment
with the 0° mark on the protractor scale
adjustment is necessary.
2. Loosen the Bevel Pointer screw using a #2
Phillips screwdriver.
3. Adjust the Bevel Pointer so that it is in
alignment exactly with the 0° mark.
4. Retighten the screw.
22