Craftsman 126.32564 Manual Del Operador página 3

MOTOR
Power Source .................................................................................................... 120V, 60Hz, 7A
Speed .......................................................................................................... 5000RPM ( NoLoad)
Double I nsulated ................................................................................................... Yes
BLADE SIZE
Diameter ............................................................................................................ 7-1/4 in.
Arbor size ........................................................................................................... 5/8in.
Blade T ype . ........................................................................ 24T TCT (Tungsten Carbide Tipped).
ROTATING TABLE
Diameter ............................................................................................................ 9 in.
CUTTING CAPACITY- LUMBER
At90 o...................................................................................................... Max Section 2 inx4 in.
At450 ................................................................................................ Max Section 2 inx2-7/8 in.
AtCompound Bevel (45 ox45 °)........................................................ Max Section 1 inx2-7/8 in.
[,_ WARNING l
To avoid electrical hazards, fire hazards or damage to the tool, use proper circuit
protection.
This tool is wired at the factory for 110-120 Volt operation.
It must be connected to a 110-120 Volt / 7 Ampere time delay fuse or circuit breaker.
To avoid shock or fire, replace power cord immediately if it is worn, cut or damaged in
any way.
Before using your tool, it is critical that you read and understand these safety rules.
Failure to follow these rules could result in serious injury to you or damage to the tool.
3