Default Setup - Rotel RSP-1068 Manual De Instrucciones

level to be used each time Zone 2 is activated.
You can select LAST to have Zone 2 activate
with the last previously used volume setting.
Or, you specify a volume from MIN (full mute)
to MAX, in 1dB increments. Note that this set-
ting cannot exceed the MAX VOL established
in the next line of the menu.
MAX VOL: Specifies the maximum volume
level for Zone 2. The volume cannot be adjusted
above this level. Settings range from MIN to
MAX, in 1dB increments.
12V TRIGGER: The 12V trigger labeled
ZONE 2 can be assigned to sources selected
from Zone 2 and will send a turn-on signal
whenever Zone 2 is activated for that source.
Select the ON setting for each source to have
the ZONE 2 trigger output send the turn-on
signal. Select the OFF setting to disable the 12V
trigger function for each source in Zone 2.
NOTE: From the factory, all 12V triggers
are set to ON, including Zone 2 SOURCE:
Off.

Default Setup

���������������������
�����������
�����������������������
�����
�����������������������
�����������������������
����
�������������
The DEFAULT SETUP menu provides access to
three functions:
• Restore all features and settings to the
original FACTORY DEFAULT settings.
• Memorize a custom group of settings as a
USER DEFAULT.
• Activate the memorized USER DEFAULT
settings.
To restore the FACTORY DEFAULT settings:
Place the highlight on the FACTORY DEFAULT
line using the UP/DOWN buttons and use
the +/– buttons to change the setting to YES.
Press the ENTER button to proceed with reset-
ting the FACTORY DEFAULT settings. The unit
will power off and then on, with the factory
settings restored. To return to the MAIN menu
without resetting the FACTORY DEFAULT set-
tings, change the entry to NO and press the
ENTER button.
39
NOTE: Resetting to factory default set-
tings will erase all stored settings including
delay settings, speaker settings, balance
settings, input settings and more. You will
lose ALL system configuration settings. Be
certain that you wish to do so before reset-
ting the factory defaults.
To memorize USER DEFAULT settings:
Many of the current configuration settings
can be stored as a USER DEFAULT, which
can be activated at any time from this menu
screen. To save the current settings as a USER
DEFAULT, place the highlight on the SET USER
DEFAULT line using the UP/DOWN buttons
and use the +/– buttons to change the set-
ting to YES. Press the ENTER button to store
the new USER DEFAULT settings. To return to
the MAIN menu without saving any changes,
change all entries on the screen to NO and
press the ENTER button.
NOTE: If there is insufficient memory to
store a USER DEFAULT configuration file,
the SET USER DEFAULT option will not be
available.
To activate memorized USER DEFAULT
settings: After you have stored a USER DE-
FAULT configuration file, you can activate those
settings at any time by placing the highlight on
the USER DEFAULT line using the UP/DOWN
buttons. Use the +/– buttons to change the set-
ting to YES. Press the ENTER button to proceed
with activating the USER DEFAULT settings. To
return to the MAIN menu without activating
the USER DEFAULT settings, change the entry
to NO and press the ENTER button.
English