Zanussi ZOP38903 Manual De Instrucciones página 18

6. Press
to start the procedure.
The bars on the symbol come on one by
one to show that the temperature in the
appliance increases. The symbol
es.
After some minutes the door locks. The
display shows the symbol
When the Pyrolysis is completed, the display
shows the time of day. The oven door stays
locked. When the appliance is cool again, an
acoustic signal sounds and the door unlocks.
To stop the Pyrolysis before it is comple-
ted, press .
Setting the end time for the Pyrolysis
You can use the End
the start of the procedure.
1. Start the Pyrolysis procedure.
2. Press
again and again until the symbol
flashes. The display shows the time for
the end of the Pyrolysis.
3. Press + or - to adjust the time for the end
of the Pyrolysis.
Oven lamp
Warning! Be careful when you change
the oven lamp. There is a risk of electrical
shock.
Before you change the oven lamp:
• Deactivate the oven.
• Remove the fuses in the fuse box or deacti-
vate the circuit breaker.
Put a cloth on the bottom of the oven to
prevent damage to the oven light and
glass cover.
Always hold the halogen lamp with a cloth to
prevent grease residue from burning on the
lamp.
1. Turn the glass cover counterclockwise to
remove it.
2. Clean the glass cover.
3. Replace the oven light bulb with an appli-
cable 300 °C heat-resistant oven light
bulb.
18
flash-
.
function to delay
Use the same oven lamp type.
4. Install the glass cover.
Cleaning the oven door
The oven door has four glass panels. You can
remove the oven door and the internal glass
panels to clean them.
The oven door can close if you try to re-
move the glass panels before you remove
the oven door.
Caution! Do not use the appliance
without the glass panels.
Removing the oven door and the glass
panels
1
Open the door
fully and hold the two
door hinges.
3
Close the oven
door to the first open-
ing position (halfway).
Then pull forward and
remove the door from
its seat.
2
Lift and turn the
levers on the two
hinges.
4
Put the door on a
soft cloth on a stable
surface.
www.zanussi.com