Safety Functions And Troubleshooting; Hood Safety Switch; Scrapping - Nilfisk-Advance Terra 132B Manual De Uso

OPERATOR MANUAL
NOTE:
For further information about the battery
charger (4, Fig. U) see the related Manual.
9. Disconnect the battery charger electrical cable (5,
Fig. U) from the electrical supply and put it back
into its housing in the machine.
10. Reassemble the battery caps (8, Fig. U)
11. Close the hood (1, Fig. U); the machine is ready to
be used.
NOTE:
When the battery charger is connected to
the electrical
functions are automatically shut off.
SAFETY FUNCTIONS AND
TROUBLESHOOTING

HOOD SAFETY SWITCH

It is activated when the machine hood is lifted up: it
stops all machine functions.
In the case where the machine starts even when the
hood is open, contact an authorized Service Center or
Retailer for Service.
TROUBLESHOOTING
TROUBLE
When the key is in the "I"
position, the machine does not
start.
The side broom does not
operate
The machine operates only
when stationary, otherwise the
red warning light turns on.
The circuit breaker (6, Fig. U)
trips frequently.
The battery run time is low.
12
supply, all machine
SOLUTION
Check that the connector 3, Fig. U is
properly connected.
Check that the hood is properly
closed.
Check the circuit breaker (6, Fig. U).
Check the Electronic circuit fuse (18,
Fig. U) integrity
Check that the battery charger is
properly connected to the battery/ies
and/or the battery charger is not
plugged in to recharge the
battery/ies.
Check the side broom fuse (7, Fig. U)
integrity
Re-charge the battery. If the problem
persists, replace the battery.
Check if the main broom pattern is
not wider than 4 cm (1.57 in)
Check that the machine is not
working on slopes higher than 2%
Check if debris is not blocking the
main broom rotation
Install a battery with greater capacity.
(Min. 140Ah)
NOTE:
If your machine has a battery charger
installed, the machine can not operate if
the charger is not on board. In case of
battery charger malfunction, contact an
Authorized Service Center.
For further information consult the Service Manual at
any Advance Service Center.

SCRAPPING

Have the machine scrapped by a qualified dismantler.
Before scrapping the machine, remove the following
components:
1. Battery
2. Polyester dust filter
3. Main and side brooms.
4. Circuit board
CAUTION!
The removed
disposed of properly and according to all
applicable laws.
components must
146 0791 000(2)2004-02
be