Bunn VELOCITY Brew NHS Instrucciones De Uso Y Cuidados página 10

cLeANING AND MAINTeNANce (cont.)
5. To clear vinegar out of brewer, pour a carafe of fresh, cold water through the
brewer. With brew funnel in place, position carafe on base plate, then close
the lid to allow the water to run through the brewer. Af ter it has run through,
empty carafe and repeat the process approximately 8-10 times
6. Replace sprayhead and brew funnel. Pour additional carafes of fresh, cold
water into the brewer as needed until water has no vinegar smell or taste.
7. Place carafe on base plate and plug in the brewer. Allow the water in the tank
to reach brewing temperature before using (approximately 15 minutes).
THerMAL cAr Afe cLeANING (bT & ST)
To disassemble the thermal carafe for cleaning, rotate the lid
counterclockwise to remove. Occasionally, the brew through
valve should be removed and cleaned. Lif t at the edge and
pull up. Use a mild, non-abrasive detergent to wash the lid
thoroughly – paying par ticular attention to the passage where
the brew through valve is located. Af ter rinsing, replace the
brew through valve into the carafe lid. Do not use a scrub pad or other abrasive
cleaning device to clean the carafe, as this will scratch the stainless steel sur face.
To remove coffee stains from inside the thermal carafe, place a paper f ilter in the
brew funnel and pour 2 teaspoons of Cascade
the paper f ilter. Slide brew funnel onto the funnel guide and open brewer lid. Pour
one carafe of cold water into brewer. Position carafe on brewer base plate and
close lid. When brewing cycle stops, remove brew funnel and discard the f ilter and
detergent; rinse funnel thoroughly. Allow carafe to sit for 10 -15 minutes. Using a
long handled, sof t bristled brush, clean inside of carafe as well as the outer rim to
remove any coffee stains or debris. Occasionally scrub the carafe pour lip and the
area around it, including the lid, with a mild detergent and warm water. Use a sof t
cloth and scrub hard. When f inished, pour out solution into sink and thoroughly
rinse carafe and lid with clean water.
The water in your brewer should be emptied whenever the brewer is taken on a
trip, shipped, stored in an unheated location with a chance of freezing, or will not
be used for an ex tended period of time. To drain your brewer:
1. Unplug brewer. Remove the brew funnel and sprayhead and set them aside.
2. Cool brewer by pouring a full carafe of fresh, cold water into the top. Place
the carafe on the base plate and close the lid. When water has stopped
f lowing from the brewer, empty the carafe. Repeat this process and set the
carafe aside.
3. Grasp the back of the brewer and carefully turn it upside down over a sink.
Most of the water in the tank will f low from the sprayhead tube opening. Some
water may f low from the area around the top lid. Continue tipping the brewer
until the f low stops.
4. Replace the sprayhead and funnel af ter the water has been drained.
Dr AINING Your brewer
powder dishwasher detergent into
®
8