By pressing the key
the display lights up and the main screen appears (see drawing D64):
Time and Date
Radio Room Temperature
10.3.
USER MODE
The normal operation of the remote control is explained below according the functions available.
Before the ignition, the screen of the remote control shows the message of drawing D65. It only shows the
room temperature and the current time.
Mon 13:22
Ignition
18º
22º
º
D66
The display shows the time, the working power and the room temperature.
Mon 13:22
Radio
Room
Thermostat
Set: 25º C
D68
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS
San 14:26
Chrono Enable
Combustion Power
Heating Power
L
Air Flow Direction
10.3.1. IGNITION OF THE STOVE
In order to ignite the stove, simply press the key
Firstly, the stove carries out an initial check-up and continues the ignition
process. After this, the display shows the message "IGNITION" (see
drawing D66).
The maximum duration of the ignition phase is 20 minutes. If after this time
there is not flame, the stove will automatically activate the alarm state and the
display will show the alarm message "Er12".
10.3.2. STOVE IN OPERATION
Once certain smoke temperature has been reached, the hot air fan starts
working and the leds will light up according to the power of the fan. Once
the ignition phase has been finished, the stove enters into "Run Mode" which
represents the normal operating mode (see drawing D67).
10.3.3. ADJUSTMENT OF THE ROOM TEMPERATURE
In the initial screen, by pressing the keys
This modification is only possible in the initial screen, inside the user menu. This option is inside a specific
menu. The value introduced is automatically saved in the memory when you exit from this option or pressing
the key SET (see drawing D68).
Er02
D
Off
18º
20º
º
M
M
R
Remote
D64
during a few seconds.
it is possible to select the temperature desired for the room.
45
Battery Charge
Error Code
State System
Room Radio Thermostat
Radio Configuration
Mon 13:22
OFF
18º
Mon 13:22
Run Mode
18º
22º
º
D65
22º
º
D67
ELSA AND PAULA