Interconnection With The Stove; User Menu; Oven Management Menu; Oven Mode - Bio Bronpi ELSA Instrucciones De Instalación, Uso Y Mantenimiento

No signal
D75
MENU
Oven Management (** Paula model only)
Heating Management
Chrono
Monitor
Manual Load
Settings
System Menu
10.4.1.

OVEN MANAGEMENT MENU

(Paula model only)
In this menu you can modify the operation of the stove, such as oven or stove. It has the following submenus:
10.4.1.1

OVEN MODE

If you activate the oven mode, the stove is controlled by the temperature set for the oven, and therefore it will
not take into consideration the ambient temperature set for the room. Instead, with the oven mode in the OFF
position, the stove is controlled by the ambient temperature of the room, although you can use the oven for
cooking food.
10.4.1.2.

TIMER

The stove has an audible warning that warns you that the cooking time you have chosen has ended, so you
should be interested in the cooking status of the food. Note that even if the timer warns the end of the selected
time, the stove continues to run normally, so it is important to remove the food if it is in the cooking state you
want.
10.4.2.

MENU FUEL MANAGEMENT

This menu modifies the combustion parameters. It has the following submenus:
10.4.2.1.

POWER

It is possible to modify the power of the stove according to the values available: power 1, 2, 3, 4, 5 or A (A=
automatic combustion). After 5 seconds, the new value will be saved and the display will return to the normal
state (see drawing D76).
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS

10.3.10. INTERCONNECTION WITH THE STOVE

If the interconnection between the remote control and the stove is lost, the display will show the message "no
signal". It would be necessary to approach the remote control to the stove so that the signal is reestablished
and the display will show the corresponding information (see drawing D75).
10.4.

USER MENU

In order to access the user menu, it is necessary to press once the key SET of the remote control.
The following table describes the structure of the user menu of the stove. The table explains the options
available for the user.
In order to move inside the submenus, it is necessary to press the keys
order to enter into each submenu. In order to modify the values, use the keys
the value. In order to exit from the submenu, it is necessary to press the key ESC.
Oven mode
Timer
Fan Calibration
Heating Power
Store Room Thermostat
Modality
Chrono Program
Thermostat Management
Radio Standby
Time and Date
Radio Test
Cange Code
Set Contrast
Key Tone
Language
S
On / Off
Value
Disable / Dayly / Weekly / Weekend
Dayly / Weekly / Weekend
Enabled / Disabled
Enable
Enabled / Disabled
47
and confirm with the key SET in
to increase or decrease
SUBMENU
Power
Pot: 3
D76
ELSA AND PAULA