Craftsman Laser Trac Manual Del Operador página 34

Tool powerswitch
(Paddle) will not
activate the tool.
Laser or LED will
not Illuminate,
Lower blade
guard will not
return to locked
posltlon_
Blade bolt is tight
but the blade sttll
sp_nsfreely
Motor or motor brush failure_
No power to tool
LasedLED switch Jammed,
Woodchfps or debds
blocking guard.
c0rrectlveAction :. :
After verifying power to the
tool and verifying that the
power switch (paddle)
activates properly,try the
following: Tap the plasttc
body of the tool with a plastic
mallet or the plastic handle of
a screwdriver and try again.
If the tool stilldoes not
operate, return for service,,
DO NOT STARE INTOTHE
LASER BEAM OR LEDI
PERMANENTEYE DAMAGE
COULD RESULTIVedfy
proper power connection
as described above.
Removeany debrisaround
Laser, q .ED switch.
Unplug tooll Remove any
debris that may be blocking
the guard. Blowout with an
alr hose if avallaNe (wear
eye protection before using
air hose°)
Lowerguard return spring DO NOT USETOOL!
brokenor dislodged. Return for repair.
Guardlock broken. DO NOT USETOOLI
Return for repair.
Guard lock spring broken.
Blade washertsnot aligned
properly with arbor shaft
DO NOT USETOOLI
Return for repair.
Loosen blade bolt. Spin
blade washerslightly untilR
aligns with arbor shaft
featuresand will no longer
spin.Retightenblade bolt.
34