Air Index; Specifications - Honda GCV160 Manual Del Usuario

Problems That May Affect Emissions
If you are aware of any of the following symptoms, have your engine
inspected and repaired by your servicing dealer.
• Hard starting or stalling after starting.
• Rough idle.
• Misfiring or backfiring under load.
• Afterburning (backfiring).
• Black exhaust smoke or high fuel consumption.
Replacement Parts
The emission control systems on your Honda engine were designed,
built, and certified to conform with EPA and California emission
regulations. We recommend the use of genuine Honda parts
whenever you have maintenance done. These original-design
replacement parts are manufactured to the same standards as the
original parts, so you can be confident of their performance. The use
of replacement parts that are not of the original design and quality
may impair the effectiveness of your emission control system.
A manufacturer of an aftermarket part assumes the responsibility that
the part will not adversely affect emission performance. The
manufacturer or rebuilder of the part must certify that use of the part
will not result in a failure of the engine to comply with emission
regulations.
Maintenance
Follow the maintenance schedule on page 6. Remember that this
schedule is based on the assumption that your machine will be used
for its designed purpose. Sustained high-load or high-temperature
operation, or use in unusually wet or dusty conditions, will require
more frequent service.

Air Index

An Air Index Information hang tag/label is applied to engines certified
to an emission durability time period in accordance with the
requirements of the California Air Resources Board.
The bar graph is intended to provide you, our customer, the ability to
compare the emissions performance of available engines. The lower
the Air Index, the less pollution.
The durability description is intended to provide you with information
relating the engine's emission durability period. The descriptive term
indicates the useful life period for the engine's emission control
system. See your Emission Control System Warranty (page 14) for
additional information.
Descriptive Term
Moderate
Intermediate
Extended
The Air Index Information hang tag/label must remain on the engine
until it is sold. Remove the hang tag before operating the engine.
E
Applicable to Emissions Durability Period
50 hours (0–65 cc)
125 hours (greater than 65 cc)
125 hours (0–65 cc)
250 hours (greater than 65 cc)
300 hours (0–65 cc)
500 hours (greater than 65 cc)

Specifications

GCV160
Length x Width x Height
(without electric start)
Length x Width x Height
(with electric start)
Dry weight (without electric start)
Dry weight (with electric start)
Engine type
Displacement
[Bore x Stroke]
Maximum output
Maximum torque
Fuel tank capacity
Fuel consumption
Cooling system
Ignition system
PTO shaft rotation
GCV190
Length x Width x Height
Dry weight
Engine type
Displacement
[Bore x Stroke]
Maximum output
Maximum torque
Fuel tank capacity
Fuel consumption
Cooling system
Ignition system
PTO shaft rotation
Tuneup
ITEM
Spark plug gap 0.028 – 0.031 in (0.7 – 0.8 mm)
Valve clearance (cold)
Other specifications
14.4 x 13.0 x 14.2 in
(367 x 331 x 360 mm)
14.4 x 13.9 x 14.2 in
(367 x 354 x 360 mm)
22 lb (9.8 kg)
26 lb (11.6 kg)
4-stroke, overhead cam, single cylinder
9.8 cu in (161 cm
[2.5 x 2.0 in (64 x 50 mm)]
5.4 bhp (4.1 kW, 5.5 PS) at 3,600 rpm
8.4 ft-lb (11.4 N•m, 1.16 kg/m) at 2,500 rpm
0.29 gal (1.1 )
0.51 lb/hph (313 g/kWh, 230 g/PSh)
Forced air
Transistorized magneto
Counterclockwise
14.4 x 13.0 x 14.5 in
(367 x 331 x 368 mm)
27.1 lb (12.3 kg)
4-stroke, overhead cam, single cylinder
11.4 cu in (187 cm
[2.7 x 2.0 in (69 x 50 mm)]
6.5 bhp (4.8 kW, 6.5 PS) at 3,600 rpm
9.74 ft-lb (13.2 N•m, 1.35 kg/m) at 2,500 rpm
0.29 gal (1.1 )
0.51 lb/hph (313 g/kWh, 230 g/PSh)
Forced air
Transistorized magneto
Counterclockwise
SPECIFICATION MAINTENANCE
Refer to page 7.
IN: 0.15 ± 0.04 mm See your authorized
EX: 0.20 ± 0.04 mm Honda dealer
No other adjustments needed.
3
)
3
)
11