11-1.8 Replacing And Adjusting The Cables - Dulevo 700 EH Manual De Uso Y Mantenimiento

EN
SWEEPER 700 EH - 700 SH - 900 EH - 900 SH
INNER SIDE FLAPS
To replace the inner side flaps (5), lift the front part of the machine and loosen screws (6) that secure the flaps
to the frame. Replace the old flaps with new ones.
CENTRE FLAPS
- Remove the rear wheels and the relevant side guards.
- Remove the rear door.
- Loosen the two flap fixing pins (3), located on the sides of the frame.
- Grasp flap (4) and pull it outwards.
REMOUNTING CENTRE FLAPS
- Fit the flaps in the same direction in which they were removed.
- Insert the two references in their holes.
- Tighten the two fixing pins and remount the machine.

11-1.8 REPLACING AND ADJUSTING THE CABLES

REPLACING THE TRACTION CABLE
Remove the traction cable as follows:
- Remove the upper bonnet of the machine.
- Loosen the security dowel located on the cable fixing pin.
- Pull the cable out of the fixing pin and remove the adjustment screw mounted on the handle.
- Press the handle and pull the cable out of its sheath.
To remount the cable:
- Fit one end of the cable into the adjustment screw of the handle (i.e. the end without the blocking ball).
- Insert the cable into its sheath.
- Hook the blocking ball to the handle.
- Slot the cable through the turned adjustment screw secured to the machine frame and then through the fixing
pin.
- Tighten the security dowel.
The position of the cable is adjusted by acting on the two adjustment screws.
REPLACING THE SIDE BRUSH LIFTING CABLE
To replace the side brush lifting cable, proceed as follows:
- Remove the upper bonnet and the front bin of the machine.
- Remove the front bumper, the right wheel and the right hand side guard.
- Loosen the cable clamp.
- Loosen the security dowel on the fixing pin.
- Remove the handle from the support and open it up.
- Pull the cable out of the two sheaths.
To remount the cable:
- Put the cable inside the handle.
- Close up the handle and fix it to its support.
- Insert the cables into their sheaths.
- Secure one end of the cable in place with the clamp and the other end with the fixing pin.
The position of the cable is adjusted by acting on the two adjustment screws.
¨
46 2008-02