Items Included; Unpack; Attaching The Legs; Connect Blood Pressure Arm Cuff To Torso - Laerdal Resusci Anne Instrucciones De Utilizacion

Items included

Please check that all listed contents below are included.
- Torso including:
- Airway Management Head
- Pelvis
- Blood Pressure arm with cuff
- IV arm
- Extrication / Rescue Legs
- Remote Control including batteries
- Remote Control cable
(for use when RF communication is not allowed)
Figure 1

Unpack

The Resusci Anne Simulator is packaged
without the legs attached. Remove the
upper body and legs from the packaging
and attach the legs to the torso.

Attaching the Legs

Each leg is attached to the pelvis with a
bolt, two washers, a spring and a wing nut.
To attach Legs:
1. Detach the torso's lower chest skin and
fold back as shown in figure 1.
2. Remove the stomach pillow insert.
3. Remove the pelvis from the torso via
bolt connection as shown in figure 1.
Note: : Be careful when detaching the pelvis
from the torso for assembly of the legs as
there are connection wires from the pelvis to
the torso.
- Power cord for AC wall adapter
- 1 bottle simulated blood
- 1 can Lubricant
- Manual defibrillation plates
- Full body soft pack
- Resusci Anne Simulator Eye Set
- Air pump
- Directions for Use
- Track suit including jacket and pants
- Educational Support Manual with predefined training scenarios
- Software CD and USB interface cable
4. Remove wing nut and washer from bolt
inserted in the leg. (Leave spring
assembly in thigh of leg.)figure 1.
5. Insert bolt through hole in pelvis
6. Slide washer and wing nut back
over bolt.
7. Use a screwdriver to drive bolt into
wing nut
8. Reattach the pelvis, with legs attached,
to the torso via bolt connector
To remove legs, reverse procedure.
4
Figure 2
Connect Blood Pressure Arm
Cuff to torso
1. Place Blood Pressure cuff on the arm.
2. Connect the clear tubing on cuff to the
blood pressure connector on simulator's
torso (figure 2). Insert the connector
and twist slightly clockwise until it clicks
into place.