Decoupling - Allmatic Clamp assist Manual De Instrucciones

8 | Operation
3. Couple CA spindle futher.
ð CA spindle is detected and the spindle ID (1) is displayed.
00000
Make sure that solely
1 spindle is spanned!
OK
CANCEL
Fig. 8: Query coupling mode
4. Press the button
ð The spindle ID flashes 3 times.
ð CA spindle is coupled at storage location.
8.4.2

Decoupling

w CA spindle coupled.
w MEE in coupling mode.
1. Keep the button
ð The corresponding display of the storage location changes to "00000".
2. Confirm decoupling with
ð The display of the storage location flashes "00000" three times.
ð CA spindle decoupled.
44 / 294
CA011
=Press SET
=Press MODE
again at the corresponding storage location.
pressed for 5 seconds at the corresponding storage location.
.
00000
ALLMATIC
00000
Clamp assist