3M DBI-SALA Ultra-Lok Serie Manual De Instrucciones página 16

8.0 Labels
Figure 20 illustrates labels on the the Self-Retracting Devices (SRDs) and their locations. All labels must be present on the SRD.
Labels must be replaced if they are not fully legible. Information provided on each label is as follows:
1) Never anchor SRD level with or below the back dorsal harness connection point. 2) Read instructions. 3) Inspect
A
Snaphook and Lifeline. 4) Inspect locking action of SRD. Should hear an audible noise when SRD locks. 5) All labels
should be present and legible. 6) Control Lifeline while it retracts into the SRD. 7) Inspect Snap Hook Impact Indicator.
Do not use if impact is indicated.
1) Read instructions. 2) Inspect Snaphook and Lifeline. 3) Inspect locking action of SRD. Should hear an audible noise
B
when SRD locks. 4) Control Lifeline while it retracts into the SRD. 5) All labels should be present and legible. 6) Do not
repair. 7) Service and repair should only be performed by Capital Safety authorized personnel.
1) Manufactured (Year/Month) 2) Lot Number 3) Model Number 4) Material 5) Length 6) Serial Number
C
EN360 SRD Fall Arrest Specifications: 1) Maximum Capacity is one person not exceeding 140 kg with a Maximum
D
Arresting Force of 6 kN.
1) Inspect locking action of SRD. Should hear an audible noise when SRD locks. 2) Read instructions.
E
EN341 Descent Specifications: 1) One person maximum. 2) Always anchor SRD overhead. 3) RSQ Descent Speed Range
F
= .6 -.9 m/s.
Do not load SRD over an edge.
G
1) Descent Mode selection 2) Fall Arrest Mode selection
I
Pull RSQ Engagement Knob out and turn until arrow points to selected mode.
J
1) Never anchor SRD level with or below the back dorsal harness connection point. 2) Read instructions. 3) Inspect
M
Snap Hook Impact Indicator. Do not use if impact is indicated.
Fall Arrest
N
EN360 SRD Fall Arrest Specifications: 1) Maximum Capacity is one person not exceeding 140 kg with a Maximum
O
Arresting Force of 6 kN. 2) Average Locking Speed is 1.4 m/s.
1) Never anchor SRD level with or below the back dorsal harness connection point. 2) Read instructions. 3) Inspect
P
Snaphook and Lifeline. 4) Inspect locking action of SRD. Should hear an audible noise when SRD locks. 5) All labels
should be present and legible. 6) Control Lifeline while it retracts into the SRD. 7) Inspect Snap Hook Impact Indicator.
Do not use if impact is indicated. 8) Edge Certified
16