Tools Required - Craftsman professional 152.229010 Manual De Instrucciones

TOOLS REQUIRED
The following toob are needed for assemMy and align-
ment. Note: hex wrenches are provided. The remaining
toob are typbaU shop tooUsand are not included with
your drHU press.
12mm Open end wrench 13mm Open end wrench
#2 PhHHpsscrewdriver Hammer and Mock of wood
The drHU press is a heavy machine; two peopb may
be required for certain assemMy operations.
DO NOT assembb the drHU press until you are sure
the tooUis unpUugged.
DO NOT assembb the drHU press until you are sure
the power switch is in the "OFF" position.
For your own safety, DO NOT connect the drHU press
to the power source until the machine is completely
assembled and you read and understand the entire
Instruction Manual.
COLUMN, BASE and TABLE ASSEMBLY
Figure 4-1
i [
Figure 4-2
O
G
2,
Attach the table raising and lowering handle (D) on
the worm gear shaft (E) and tighten the set screw
(F) against the fiat (G) on the worm gear shaft, See
Figure 4-2,
Figure 4-3
Attach the column (A) to the base (B) using the
four MIO x 40mm hex head screws (C).
See Figure 4-1.
3. Thread the stud of the table lock handle (H) into the
hob (I) in the rear of the table bracket. See Figure
4-3.
Figure 4-4
J
K
12
4,
Lay the table (J) upside down and place the table
extension support (K) into the bottom of the table.
NOTE: The table extension support can be posi-
tioned either to the right or left. See Figure 4-4.