Craftsman professional 152.229010 Manual De Instrucciones página 24

Figure 18-2
2.
While the handUe (A) is disengaged, rotate it to the
desired position and reUease the handUe, The ham
due is spring Uoaded and wHU engage by Ueave it at
rest,
Figure 18-3
TABLE EXTENSUON
Figure 19-1
D
Figure 19-2
D
A
B
C
A
A
C
B
3.
4.
Figure 18-3 shows the handUe repositioned and the
handUe is again ready for use,
To move the chuck down for a drHU operation, pull
down on the handUe (A),
1.
To move the table extension support (A), loosen the
two knobs (B) under the table (C), See Figures
19-1 and 19-2,
2, Position the tame extension support to its desired
position and tighten the two knobs under the tame,
3, Ufthe height of the tame extension (D) needs to be
adjusted, Uoosen the knob (E),
4, Position the tame extension to its desired height
and tighten knob,
24