Descargar Imprimir esta página

Craftsman professional 152.229010 Manual De Instrucciones página 16

Gama de velcidades de perforacion

Publicidad

Idiomas disponibles

Idiomas disponibles

LASER ASSEMBLY
Figure
6-3
MAKE CERTAIN the drill press is disconnected from
the power source,
LASER LIGHT - DO NOT STARE INTO BEAM,
APERTURE,
or into a reflection from a mirrorqke
surface,
Figure
6-1
5,
6,
Hace Uaser around coUumn (G) and against the
head casting (H) and fasten the damp secureUy at
the coUumn,
Make sure Uaser housing is positioned so that one
Uaser is to each side of the head casting,
1,
Place clamp (A) through openings (B) in laser
housing,
Figure
6-2
F
D
E
\
C
2,
Remove battery cover (C) from laser housing,
3,
Connect a 9-volt battery (D) (not included) to
battery terminal (E),
4,
Place battery into battery compartment
(F) and
replace battery cover,
16
A
To help reduce the tendency of the drill press to tip
over, slide, or walk, it can be fastened to the floor
surface, The machine base has four hobs (A), one at
each corner where it can be fastened (hardware not
included),
See Figure 7-1,

Publicidad

loading