Inserting And Removing The Batteries - Philips RESPIRONICS SimplyGo Manual De Instrucciones

SimplyGo User Manual

Inserting and Removing the Batteries

Your SimplyGo device comes with one rechargeable lithium ion battery� To
insert it correctly, follow these steps�
1� Place your device in a well ventilated location and make sure it is
turned off.
Note:
The SimplyGo device is shipped from the factory with the battery
removed�
Caution: Only remove the battery when the SimplyGo is turned off.
Never remove the battery while the device is
operating�
2� To remove the battery, insert your fingers into
the opening in the battery handle� Steadily pull
upward on the handle until the battery is released
from the enclosure� Continue to lift the battery
until it is entirely removed from the battery
compartment� If the device has been operating,
the surfaces may be warm to the touch� This is
normal�
3� Check the battery gauge (shown below)� To do so, press the white
button (shown below) on the battery and watch how many LEDs
light up� If the batteries are low, you can recharge them� See the
Charging the Battery with AC Power Supply section�
No. of LEDs Battery Charge
4 LEDs Light:
3 LEDs Light:
2 LEDs Light:
1 LED Lights:
1 LED Blinks
3 Times:
10
75% to 100% full
50% to 75% full
25% to 50% full
10% to 25% full
Battery is less than
10% full and
needs to be
recharged