Operating The Simplygo Device And Changing Device Settings - Philips RESPIRONICS SimplyGo Manual De Instrucciones

SimplyGo User Manual
Operating the SimplyGo Device and Changing
Device Settings
You can change all device settings using the buttons on the control panel�
This includes starting the device, stopping it, silencing an alarm, and changing
oxygen flow�
To start your SimplyGo device, follow these steps�
1� Connect a nasal cannula to the patient cannula connector on top of
the device, as shown� Ensure that the cannula is routed to prevent it
from being pinched or kinked to avoid a disruption of oxygen flow�
Note: A standard single lumen nasal cannula and
tubing (not supplied) should be used to
deliver oxygen from the SimplyGo device�
The device works with cannula tubing up to
30 ft� (9 m)�
2� To start the device, press the Power
button� After the first press, the display screen and the 5 button
backlights turn on and you will see a screen similar to the one shown
below�
i
tem
1
2
3
4
5
6
7
16
1
2
7
6
D
esCriPtion
Push Power again to turn the device on�
Total number of operating hours for the device�
Indicates if the battery is being charged�
Amount of full charge currently in the battery�
External power is connected�
Software version in the device�
Indicates the allowable modes configuration
of the device� Note: This may not display on all
devices� This is normal�
3
4
5