To Do A Check Of The Parking Brake; To Do A Check Of The Parallelism Of The Cutting Deck; To Adjust The Parallelism Of The Cutting Deck - Husqvarna P 520DX Manual De Usuario

To do a check of the parking brake

1. Park the product on a hard surface that slopes.
Note:
Do not park the product on a grass slope
when you do a check of the parking brake.
2. Push the parking brake forward.
3. If the product starts to move, let an approved service
agent adjust the parking brake.
4. Pull the parking brake rearward to release the
parking brake.
To do a check of the parallelism of the
cutting deck
1. Do a check of the air pressure in the tires. Refer to
Tire pressure on page 39 .
2. Park the product on a level surface.
3. Lower the cutting deck to mow position.
4. Set the cutting height lever to the middle position.
5. Measure the distance between the ground and the
front and rear edges of the cutting deck.
a) Measure Combi 132 and Combi 155 in 2 areas.
Make sure that the rear edge is 6–9 mm (¼–⅜
in.) higher than the front edge.
1593 - 002 - 22.12.2020
b) Measure Combi 132 X and Combi 155 X in 4
areas. Make sure that the rear edge is 6–9 mm
(¼–⅜ in.) higher than the front edge.
6. Adjust the cutting deck if it is necessary. Refer to
adjust the parallelism of the cutting deck on page
33 .
To adjust the parallelism of the cutting
deck
1. Turn the track rod to extend it or make it shorter.
Extend the track rod to lift the rear edge of the
cutting deck. Make the track rod shorter to lower the
rear edge of the cutting deck.
Note:
For Combi 132 X, Combi 155 X, adjust the
track rods on the 2 sides.
2. Tighten the nuts on the track rod.
3. Do a check of the parallelism. Refer to
check of the parallelism of the cutting deck on page
33 .
To
To do a
33