To Replace The Belt On The Cutting Deck - Husqvarna P 520DX Manual De Usuario

3. Attach the service stay to the red point below the
bottom plate.
4. Pull the pin on the other end of the service stay.
Attach the service stay to the red mark on the pipe
on the cutting deck.
5. Start the engine.
6. Move the lever for the hydraulic lift arms rearward to
lift the cutting deck fully.
7. Attach 1 end of the safety straps around the pipe
adjacent to the steering column (A).
B
40
A
8. Attach the other end of the safety strap around the
pivoting wheels of the cutting deck (B).
9. To put the cutting deck in mow position, follow the
instructions in the opposite sequence.

To replace the belt on the cutting deck

1. Remove the 3 screws that hold the belt cover.
2. Remove the belt cover.
3. Attach the service stay to the tension spring.
4. Push the service stay and remove the belt.
5. Attach the belt around the pulleys as shown in the
illustration.
1593 - 002 - 22.12.2020