Rough-In Electrical - Best IM32I100SP Manual De Instrucciones

STRUCTURAL REQUIREMENTS
The total weight of the hood is 100 lbs. as supplied. Special structure consider-
ations must be made to ensure proper installation. The mounting brackets need to
be mounted to 2" nominal lumber. Hollow wall anchors should not be used at any
time. Fig. 4.
ROUGH-IN DETAILS

ROUGH-IN ELECTRICAL

This hood is hard wired via a junction box located in the hood canopy. Incoming
power should be located as shown on the drawings above.
WARNING: Electrical wiring must be done by a qualified person in accor-
dance with all applicable codes and standards.
12"
3-1/2"
2-3/4"
- 7 -
OUTLINE
OF CEILING
CANOPY
2 X 6 BLOCKING
(MIN.) MUST BE
FLUSH WITH
CEILING JOISTS
FRAMING
INCOMING
POWER
LOCATION
2 X 4
Fig. 4