Metra 99-5816 Instrucciones De Instalación página 3

5. Unclip and remove the vent panel
at the top of the factory radio trim
panel. (Figure E)
6. Remove (2) 9/32" screws behind
the vent panel previously removed.
(Figure F)
7. Unclip the factory radio trim panel
assembly. Unplug and remove
the assembly.
Note: Some early models had a
ground strap attached to the radio
chassis and the sub dash with an
8mm bolt. You will need to unbolt
this strap to remove the factory
radio trim panel assembly.
8. Remove (4) T-20 Torx screws
securing the climate controls to the
factory radio trim panel assembly,
and then remove the controls from
the assembly. Retain the screws
and climate controls for re-use
during kit preparation. (Figure G)
Dash Disassembly
(Figure E)
(Figure F)
99-5816
9. Remove (4) T-20 Torx screws
securing the accessory socket
panel to the factory radio trim
panel assembly and remove the
socket panel from the assembly.
Retain the screws and accessory
socket panel for re-use during kit
preparation. (Figure G)
10. Unclip and remove the passenger
air bag light and the switch panel
blank plates. Retain the air bag
light and blank plates for re-use
during kit preparation.
Continue to kit preparation
3
(Figure G)