Publicidad
Idiomas disponibles
Idiomas disponibles
ISO DIN radio provision
1. Remove the metal DIN sleeve and
trim ring from the aftermarket radio.
2. Align the holes in the ISO DIN
brackets with the holes in the radio
and then secure the brackets to
the radio with the screws included
with the radio. (Figure A)
Note: The screws provided with
certain radios may create a
clearance problem during radio
installation. In these cases it may
be necessary to trim the walls
of the dash bezel to provide the
proper clearance.
3. Locate the factory wiring harness
and antenna connector in the
dash and make all necessary
connections to the radio. Metra
recommends using the proper
mating adapters from Metra and/or
AXXESS. Re-connect the negative
battery terminal and test the radio
for proper operation.
Kit Assembly
(Figure A)
(Figure B)
99-9008
4. Slide the radio into the radio cavity
until it clicks in. (Figure B)
5. Position the ISO DIN housing over
the radio with the side notches in
the upper corners. Secure with the
(2) Torx T-10 screws removed in
dash disassembly. (Figure C)
6. Attach the ISO DIN trim plate onto
the ISO DIN housing. (Figure D)
3
(Figure C)
(Figure D)
Publicidad
