Tractel bravo 2006/42/CE Manual De Empleo Y Mantenimiento página 7

Periodically, and especially after an intensive
use, lubricate the mechanical parts. Never let
brake discs receive some lubricant. They have
to be kept clean and dry.
Check regularly the condition of the hooks with
the opening indicator of the hooks, particularly
in case of overload (see technical data sheet
T2206).
If any damage is observed, return the
bravo™ hoist to a TRACTEL
workshop.
8. EMERGENCY PROCEDURE
IN CASE OF AN INCIDENT
In the event of a blocked chain or any other
malfunction of the unit, immediately stop the
maneuver without attempting any further
actions and call in the necessary qualified
personnel to remove the load and intervene on
the hoist.
Immediately set up a safety perimeter around
the hoist and directly under the load to prevent
access by any unauthorized persons.
Return the hoist to a TRACTEL
repair agent.
9. DO NOTS
Do not:
- Use the hoist if it has not been inspected for
more than 1 year.
- Use the hoist if its chain shows any
deformation or wear.
- Use the hoist with any chain other than a
genuine TRACTEL ® chain.
- Use the hoist with an extension on the
actuating handle.
- Use the hoist if the chain is not correctly
positioned in the lifting mechanism.
- Make any changes to the hoist.
- Use any parts or components other than
genuine TRACTEL ® parts and components.
- Use a hoist which is not in good condition .
- Use the hoist without first having perform the
checks described in this manual.
- Secure the hoist to a support which is not
sufficiently strong.
- Secure the hoist by any means other than its
suspension hook.
- Clamp the suspension hook.
- Attempt to lift fixed or blocked loads.
- Set the selector lever to the "0" position when
the chain is tensioned .
- Use a high pressure cleaner or chemical
products (acids, chlorinated products) to
clean the hoist.
- Use the hoist at loads exceeding its working
load limit (WLL).
- Use the hoist in an explosive environment
(device not compliant with ATEX directive) or
in a highly corrosive environment.
- Use the hoist at temperatures of less than
–10°C or greater than +50°C .
- Use the hoist to lift a load when the wind
® -approved repair speed is greater than 50 km/h.
- Use the hoist, even occasionally, to lift or
move persons.
- Use the hoist for operations other than those
for which it is intended or using setup
diagrams other than those described in this
manual.
- Use the hoist under lighting conditions which
are not sufficient to clearly observe the load
along its entire path.
- Apply the load to the hook end.
- To force the lever when the lower end stop
blocks the hoist.
- Pull sideways on loads to be lifted.
® -approved - Use the bravo™ load chain as a sling.
- Raise or lower a load without having a clear
view of the entire path.
- Allow the load to swing under the hoist.
- Stand under or move around under the load.
- Allow the bravo™ load chain to rub against
an obstacle.
- Actuate the load wheel during a maneuver or
when the chain is tensioned.
- Fasten a load to the low limit stop.
- Strike the actuating handle.
- Intervene on the hoist without first having
removed the load from the hoist.
- To intervene on the load limiter adjustment.
7
GB