Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
ISO DDIN radio provision (95-2001):
1. Attach the radio brackets to the
inside edge of the radio trim plate.
(Figure A)
2. Slide the radio into the completed
assembly, and then secure the
radio to the assembly using the
screws supplied with the radio.
(Figure B)
Note: The spacers included in
the kit may be necessary to
adapt to the slight differences
from one vehicle to another. If
the kit/radio assembly does not
meet the backside of the factory
radio opening, use the spacers to
eliminate that space.
Continue to All Applications
95-2001 or 99-2001
Kit Assembly
(Figure A)
(Figure B)
®
DIN radio provision (99-2001):
1. Remove the metal DIN sleeve from
the aftermarket radio.
2. Slide the sleeve into the radio
housing and secure by bending
the metal locking tabs outward.
(Figure C)
Note: The included spacer is to be
used in applications where there is
not enough depth in the radio cavity.
3. Slide the radio into the sleeve until it clicks in. (Figure C)
4. If not installing an equalizer, snap the equalizer dummy plate onto the kit.
Continue to All Applications
All applications:
1. Locate the factory wiring harness and antenna connector in the dash. Metra
recommends using the proper mating adapter from Metra or AXXESS. Test the
radio for proper operation.
2. Reassemble the dash in reverse order of disassembly.
19
(Figure C)
Publicidad
Capítulos
Tabla de contenido
