Single Cycle Lock; Preset Lock; Setting Or Modifying A Cycle - Drucker Diagnostics HORIZON SERIE Manual Del Operador

S C L
INGLE YCLE OCK
Lock on Single Cycle
Cancel Single Cycle
P L
RESET OCK
Enter Settings
Lock Saved Cycles
Cancel Preset Lock
S M
ETTING OR ODIFYING A
Up to 10 cycles can be named, programmed for time, speed, and braking, and saved in memory.
Cycle Selection
Enter Programming
Navigate between
Change Parameter
Displaying the
Correct g-force
Select desired cycle. Press and hold the UNLOCK button for 5
seconds. Two beeps will confirm that cycle selection is locked.
To re-enable cycle selection, press and hold the UNLOCK button
for 5 seconds. Three beeps will confirm that cycle selection is now
Lock
unlocked.
Press the GEAR button.
Mode
Press and hold the UNLOCK button for 5 seconds. Two beeps will
confirm that the Preset Lock is active.
With lid open and while not in Settings mode, press and hold the
UNLOCK button for 5 seconds until two beeps are heard. Saved
cycles can again be edited or programmed.
C
YCLE
Press the up and down buttons next to the screen to select the
desired cycle.
Press the GEAR button.
Mode
Use the left and right arrow button until the parameter to be
Parameters edited is blinking and underlined.
To change the parameter shown on the display, use the up and
Values
down buttons next to the screen.
HORIZON 6 Flex FA only: To display the real g-force (RCF) for the
cycle, the right tube holder must be selected. Universal blue tube
holders accommodate 75 and 100 mm tubes. 125 mm tubes
require the orange tube holder. If the tube holder selection in the
program does not match the tube holder used, the RCF number
displayed will not reflect the actual value.
| 5